User's Manual

DragonWave Inc. 18
AirPair 100 UL 24 GHz Product Manual
4.4. Set AirPair Frequency
This section describes how to set the radio frequency and transmit power using
the CLI. Before setting the frequency or transmitting power, ensure that the radio
is connected to the modem through a serial port.
Note: One must be GO and the other must be Return. Vertical and horizontal
polarizations are completed during install.
Procedure 4-3
Set AirPair Frequency available and Transmit Power
Follow this procedure to set the 24 GHz AirPair frequency channels for pre-
defined frequency pairs (coupled frequencies) and to set the gain.
Note: To perform this procedure, you must have NOC user rights.
Required Action Steps
login as an NOC user Logs in as an NOC user.
Sequence:
Enter an NOC username:
Username <username> press Enter
Enter an NOC password:
Password: <password> press Enter
get radio band Displays the type (band) of radio that the user expects to connect to the
modem.
Sequence:
get radio band press Enter
The system responds:
Currently selected Radio Band: [none/un24].
Radio bands available in the system:
none fcc18a fcc18b fcc18c ic18a ic18b
ic18c fcc23a fcc23b fcc23c fcc23d ic23a
ic23b fcc28a fcc28b china23 un24
set radio band [none /
un24]
Sets the band of radio to which the user expects to connect the modem.
Sequence:
set radio band [band] press Enter
where
band is none / un24
The system responds:
Radio band Selected [none/un24].