User's Manual

www.dragino.com
LPS8 LoRaWAN Gateway User Manual 8 / 37
2 Access and Configure LPS8
The LPS8 is configured as a WiFi Access Point by factory default. You can access and configure the
LPS8 after connecting to its WiFi network, or via its WAN Ethernet port.
2.1 Connect via WiFi
At the first boot of LPS8, it will auto generate a WiFi network
called dragino-xxxxxx
Note: In latest version firmware, it has been password
protected and the password is:
dragino+dragino
You can use a PC to connect to this WiFi network. The PC will
get an IP address 10.130.1.xxx and the LPS8 has the default IP
10.130.1.1
Note: If device has been configured to work in WiFi Client Mode, the WiFi AP mode will be
disable and user can’t see the dragino wifi SSID.
2.2 Connect via Ethernet
Alternatively, you can connect your PC to the LPS8 WAN port via Ethernet cable and obtain an IP
address via DHCP. User can see this ip address from uplink router.
The WAN port also has a fall back ip address for access if user doesn’t connect to uplink router.
2.3 Access Configure Web UI
Web Interface
Open a browser on the PC and type in the LPS8 ip address (depends on your connect method)
http://10.130.1.1/ (Access via WiFi AP network)
or
http://IP_ADDRESS or http:// IP_ADDRESS:8000 (The web port has been changed to
8000 in WAN interface(WAN port or WiFi Client Mode) since firmware 5.3.xxx firmware)
You will see the login interface of LPS8 as shown below.
The account details for Web Login are:
User Name: root
Password: dragino