Data Sheet

Test Report
No. C160907030001 Date: Sep 14, 2016 Page 10 of 17
Eurones (Dongguan) Consumer Products Testing Service Co., Ltd. t (86-769) 38937858 f (86-769) 38937859 Http:// www.cpstlab.com
3/F., Huafeng Building, No.77, Hetian Avenue, Houjie, Dongguan, Guangdong, China. Postcode: 523945 E-mail: [e-mail]
400 111 6218
This Test Report is issued by the Company subject to its General Conditions of Service printed overleaf or available on request and accessible at
www.cpstlab.com. Attention is drawn to the limitations of liability, indemnification and jurisdictional issues defined therein. Unless otherwise stated the
results shown in the test report refer only to the sample(s) tested. This test report cannot be reproduced, except in full, without prior written permission
of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this report is unlawful and offenders may be
prosecuted to the fullest extent of the law.
3. 2 Test for Heavy Metals
– Lead, Cadmium, Hexavalent Chromium and Mercury Tests according to IEC 62321-4:2013 &
IEC 62321-5:2013 & IEC 62321-7-1:2015& IEC 62321:2008.
Element
Total
Cadmium
[mg/kg]
Total
Lead
[mg/kg]
Total
Mercury
[mg/kg]
Hexavalent
Chromium
[-]
Hexavalent
Chromium
[mg/kg]
Detection Limit 5 5 5 ∆ 5
RoHS Requirements 100 1000 1000 # 1000
Sample 005 / 29481Φ / / /
Sample 015 / 39472Φ / / /
Sample 016 / 37478Φ / / /
Sample 042 / / / / N.D.
Note:
1. All Concentrations express in “mg/kg”(milligram per kilogram), mg/kg ~ ppm.
2. “N.D.” = “Not Detected”.
3. Boiling-water-extraction:
Negative = Absence of Cr(VI) coating / surface layer: the detected concentration in
boiling-water-extraction solution is less than 0.10μg with 1cm2 sample surface area.
Positive = Presence of Cr(VI) coating / surface layer: the detected concentration in
boiling-water-extraction solution is greater than 0.13μg with 1cm2 sample surface area.
Inconclusive =the detected concentration in boiling-water-extraction solution is greater than 0.10μg and less
than 0.13μg with 1cm2 sample surface area.
4. # =Positive indicates the presence of CrVI on the tested areas.
Negative indicates the absence of CrVI on the tested areas.
5. “-” =Not regulated
6.“Φ”=the sample 005, sample 015, sample 016 are copper alloy.The lead content
which is under 4% is exempted from the requirement of directive 2011/65/EU（Rohs）.