User manual

Draco vario DVI KVM Extender
In this case, choose X-ON / X-OFF software handshake for traffic control
at printer and PC.
Connection Format
DTE (Data Terminal Equipment)
Speed
Up to 115,200 Baud
Data Format
Format independent
Data Transmission
 RxD (Receive Data)
 TxD (Transmit Data)
Traffic Control
The following signals are transmitted
(hardware handshake):
 RTS (Request To Send)
 CTS (Clear To Send)
 DTR (Data Terminal Ready)
 DSR (Data Set Ready)
Pos: 84 /806-IHSE/ Technische Daten/Schni ttstellen/474- xx (Analoge mod_133249 1046975_6.doc @ 58270 @ 3 @ 1
7.1.9 Analog Audio Interface
Audio-Schnittst elle) @ 7\
The analog audio option supports a bidirectional stereo audio
transmission, in near-CD quality.
The audio interface is a 'line level' interface and it is designed to transmit
the signals of a sound card (or another 'line level' device) as well as to
allow the connection of active speakers to the CON Unit.
Stereo audio can be transmitted bidirectionally at the same time.
Connection of a microphone:
Connect the microphone to the 'audio' input of the CON Unit. There are
two ways to establish this connection:
 The output of the CPU Unit is connected to the microphone input of
the sound card (red). Adjust the sound card to provide an additional
amplification (20 dB).
 The output of the CPU Unit is connected to the audio input of the
sound card (blue). Choose this connection if the microphone has its
own pre-amplifier.
The CON Unit can also provide pre-amplification of a microphone. Open
the CON Unit, locate the 'MIC' jumper on the audio board and close the
pins.
60 2014-11-11