Owner`s manual

To Exit Remote Start Mode And Drive The Vehicle

Before

the end of 15 minute cycle, press and release the

UNLOCK button on the RKE transmitter to unlock the

doors and disarm the Vehicle Security Alarm (if equipped).

Then, prior to the end of the 15 minute cycle, press and

release the START/STOP button. If the START/STOP but-

ton is not present, insert the Key Fob into the ignition

switch and turn the switch to the ON/RUN position.

NOTE:

• For vehicles not equipped with the Keyless Enter-N-

Go™ feature, the ignition switch must be in the

ON/RUN position in order to drive the vehicle.

• For vehicles not equipped with the Keyless Enter-N-

Go™ feature, the message “Insert Key/Turn To On”

will display in the EVIC until you insert the Key Fob.

Once inserted, the message “Turn To On” will display

in the EVIC until you turn the Key Fob to ON/RUN.

• For vehicles equipped with the Keyless Enter-N-Go™

feature, the message “Push Button/Insert Key” will

display in the EVIC until you push the START button.

Cancel Remote Start

Remote Starting will also cancel if any of the following

occur:

• The engine stalls or engine speed exceeds 2500 rpm

• Any engine warning lights come on

• Low Fuel Light turns on

• The hood is opened

• The hazard switch is pressed

• The shift lever is moved out of PARK

• The brake pedal is pressed

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 33