Operating instructions

Adjusting the Differential Lock In/Out Cable

NOTE: If the Differential will not Lock In or Out, the Cable may need adjustment.

1. Locate the Differential Lock In/Out Cable along the right Handlebar. There

is an In-Line Adjuster to change the length of the Cable (Figure 26a).

2. With the Lock In/Out Lever in the Out position (lever back), there should be

a slight amount of slack in the Cable exposed at the spring end (Figure 26b)

and the Lock In/Out Sleeve should be all the way to the right (toward the

outside).

NOTE: If the cable appears to have plenty of travel and the Sleeve is still not fully to

the outside, you may have to clean and lubricate the Sleeve. See page 17 for

Lubrication.

3. You can take the slack out of the cable by holding the Hex Flat Section at the

top of the In-Line Adjuster and rotating the body of the In-Line Adjuster in

the clockwise direction as you look up the Cable toward the Control Panel. If

the Cable is too tight, you can loosen the Cable by twisting the adjuster in

the opposite direction (Figure 26a).

Removing the Wheels

Tools needed:

• 3/4" Socket with extension

4. Loosen the Wheel Nuts a couple of turns with the Wheel on the ground.

5. Block the machine so the Wheel you are removing is off the ground.

6. Remove the three (3) Nuts and slide the Wheel off (Figure 27).

7. Replace the Wheel and finger-tighten the Wheel Nuts before unblocking the

machine.

8. Tighten the Wheel Nuts with the Wheel resting on the ground.

Before performing any maintenance procedure or inspection, stop the

engine, wait five (5) minutes to allow all parts to cool. Disconnect the spark

plug wire(s), keeping it away from the spark plug(s).

Before performing any maintenance procedure or inspection, stop the

engine, wait five (5) minutes to allow all parts to cool. Disconnect the spark

plug wire(s), keeping it away from the spark plug(s).

In-Line

Adjuster

Hex Flat

Clockwise

to tighten

Figure 26a

Figure 26b

Lock In/Out Cable Spring

Lock In/Out Sleeve in

the Out position

Out

Lock

In/Out

Sleeve

Figure 27

Wheel Nut