Service manual

17-24 APPENDIX
Cable, Wire, and Hose Routing
1. Main Harness (Run the main harness un-
der the frame pipe.)
2. Battery (–) Cable
3. Bands
4. To Rear Brake Light Switch
5. To Fuse Box
6. To ECU
7. To Actuator Controller
8. To Starter Circuit Relay
9. To Battery (–) Cable
10. Reset Connector
11. Fuel Pump Lead Connector
12. To Radiator Fan Relay and Fuel Pump
Relay
13. Kawasaki Diagnostic System Connector
14. To Starter Control Relay (Brake)
15. To Vehicle-down Sensor
16. To Starter Control Relay (Neutral)
17. Accessory Connector
18. Clamps
19. To Reverse Light (Europe Model)
20. Tail/Brake Light Lead
21. Regulator/Rectifier
22. Run the regulator/rectifier lead to the in-
side of the frame pipe.
23. Band (Clamp the accessory lead.)
24. White Tapes
25. Run the lead under the frame pipe.
26. Forward/Reverse Detecting Sensor Lead
Connector
27. Clamp (Insert the clamp into the hole of
the frame.)
28. To Speed Sensor
29. Band (Pass the band through the hole of
the frame bracket.)
30. To Engine Brake Actuator
31. To Drive Belt Failure Detecting Switch
32. Engine Ground Terminal
33. Neutral Switch Lead Connector (LG
Lead)
34. Reverse Switch Lead Connector (R/W
Lead)
35. Front