Service manual

16-74 ELECTRICAL SYSTEM
Actuator Control System
•
Measure the resistance between the following terminals
in the actuator lead connector [A].
Special Tool - Hand Tester: 57001-1394
Actuator Internal Resistance
4(Red)-6(Black): 3∼ 15 Ω
1 (Orange) - 3 (Blue): 3.5 ∼ 6.5 kΩ
2(Yellow)-3(Blue): 630∼ 3,720 Ω
If any reading is not within the specified range, replace
the 2WD/4WD actuator.
Check 2. Engine Brake Actuator Inspection
•
Remove:
Actuator Lead Connector [A]
•
Measure the resistance between the following terminals
in the actuator lead connector [A].
Special Tool - Hand Tester: 57001-1394
Actuator Internal Resistance
4(Red)-6(Black): 3∼ 15 Ω
1 (Orange) - 3 (Blue): 3.5 ∼ 6.5 kΩ
2(Yellow)-3(Blue): 630∼ 5,330 Ω
If any reading is not within the specified range, replace
the engine brake actuator.
Check 3. Controller Power Supply Inspection
NOTE
○
Be sure the battery is fully charged.
•
Remove:
Seat (see Seat Removal in the Frame chapter)
•
Connect:
Controller Connector [A]
Hand Tester [B] (range: DC 25 V)
Test er ( +) → Connector (BR) Terminal [9]
Test er ( –) → Connector (BK/Y) Terminal [10]
○
Install the needle adapters on the tester leads.
Special Tools - Hand Tester: 57001-1394
Needle Adapter Set: 57001-1457
•
Turn ON the ignition switch.
Controller Power Supply Voltage
Standard: near Battery Voltage
If the reading is not battery voltage, check the wiring har-
ness, 30 A fuse, or ignition switch.