Service manual

16-66 ELECTRICAL SYSTEM
Meter
Drive Belt Failure Mode Memory Clearing
Procedure
A flashing BELT check indicator LED (Light Emitting
Diode) l ight means that the drive belt failure detection
system has activated. The belt check indicator light will
illuminate and stay on when activated b y the 100 hour belt
check s ystem.
NOTE
○
Follow the instruction on page 2-25 of this Service Man-
ual to complete the necessary inspections.
○
After completing the inspections, follow these instruc-
tions to clear the system memory and turn off the light.
•
Turn off the ignition switch.
•
Remove the seat (see Seat Removal in the Frame chap-
ter).
•
Disconnect both sets of 4 pin connectors [A] in the elec-
trical parts case.
•
Reconnect these 4 pin connectors to their opposite gray
to black and black to gray as shown.
•
Turn on the ignition switch.
•
Observe the belt check indicator light [A].
○
It should be flashing quickly.
•
Disconnect the belt switch a t the 2 pin connectors [A]
above the torque converter cover.
•
Observe the belt check indicator light.
○
It should be flashing slowly.
○
Let it flash for at least five seconds.
NOTE
○
More than five seconds is OK.
•
While observing the belt check indicator light, turn off the
ignition switch.