Service manual

ELECTRICAL SYSTEM 16-55
Lighting System
•
Install the removed parts.
[A] Bolt and Collar [L = 6 mm (0.24 in.)]
[B] Bolt and Collar [L = 4 mm (0.16 in.)]
[C] Bolt (only)
Tail/Brake Light Bulb Replacement
•
Remove:
Tail/Brake Light Lens Mounting Screws [A]
Tail/Brake Light Lens [B]
•
Push the bulb [A] in, turn it c ounterclockwise, and pull it
out.
•
Be sure the socket is clean.
•
Insert the new bulb by aligning the pins [A] with the
grooves in the walls of the socket.
•
Push the bulb in, turn it clockwise, and release it. It should
lock in position.
•
Tighten:
Torque - Tail/Brake Light Lens Screws: 1.0 N·m (0.10 kgf·m,
8.8 in·lb)
Tail/Brake Light Removal
•
Open the clamp [A].
•
Disconnect:
Taillight Connector [B]