Service manual

ELECTRICAL SYSTEM 16-45
Electric Starter System
If the O-ring [A] shows wear or damage, or if it is hard-
ened, replace it with a new one.
•
Apply a small amount of engine oil to the O-ring.
•
Install:
Starter Motor [A]
Clamp [B] (as shown)
•
Tighten:
Torque - Starter Motor M ounting Bolts: 8.8 N·m (0.90 kgf·m,
78 in·lb)
•
Position the starter motor cable [A] as shown.
About 20° [B]
•
Tighten:
Torque - Starter Motor Cable Mounting Nut: 6.8 N·m (0.69
kgf·m, 60 in·lb)
•
Slide back the rubber cap to the original position.
•
Apply grease to the O-ring [A] in the joint duct [B].
•
Install:
JointDuctandCollars[C]
Clamp [D] (as shown)
•
Tighten the joint duct bolts [E].
Starter Motor Disa ssembly
•
Remove the starter motor (see Starter Motor Removal).
•
Take off the starter motor through bolts [A] and remove
the both end covers [B].