Service manual

2-30 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Fill the gear case up to the bottom of filler opening with
the oil specified below.
Front Final Gear Case Oil
Type:
API SF or SG
API SH, SJ or SL with JASO MA
Viscosity:
SAE 10W-40
Capacity : 0 .40 L (0.42 US qt)
NOTE
○
Depending on the atmospheric temperature of your rid-
ing area, the engine oil v iscosity should be changed ac-
cordingtothechart.
•
Be sure the O-ring [A] is in place, and tighten the filler cap
[B].
○
Apply grease to the O-ring.
Torque - Front Final Gear Case Oil Filler Cap: 29 N·m (3.0
kgf·m, 22 ft·lb)
Rear Final Gear Case Oil Change
•
Warm up the oil by running the v ehicle so that the oil will
pick up any sediment and drain easily. Then stop the
vehicle.
•
Park the vehicle so that it is level, both side-to-side and
front-to-rear.
•
Place an oil pan beneath the rear final gear case and
remove the oil drain bolt [A].
WARNING
When draining or filling the final gear case, be care-
ful that no oil gets on the tire or rim because oil will
deteriorate the tire. Clean off any oil that inadver-
tently gets on them with a high-flash point solvent.
•
After the oil has completely drained out, install the oil drain
plug with a new aluminum gasket.
Torque - Rear Final Gear Case Oil Drain Bolt: 15 N·m (1.5
kgf·m, 11 ft·lb)
•
Fill the final gear case up to the bottom of filler opening
with the oil specified below.
Rear Final Gear Case Oil
Type:
MOBIL FLUID 424, CITGO TRA NSGARD
TRACTOR HYDRAULIC FLUID or EXXON
HYDRAUL 560
Capacity: 0.72 L (0.76 U S qt)
○
Do not use mixing the above oils.