Service manual

PERIODIC MAINTENANCE 2-27
Periodic Maintenance Procedures
Actuator Lever (Engine Brake Control Lever)
Assembly Inspection
•
Measure the width [A] of the plastic guide shoe [B] of the
actuator lever assembly.
If the guide contact area width is greater than the service
limit, replace the actuator lever assembly.
Actuator Lever Guide Shoe
Service Limit: 6 mm (0.24 in.)
Engine Lubrication System
Engine Oil Change
•
Support the vehicle so that it is level, both side to side and
front to rear after warming up the engine.
•
Remove the engine oil drain bolt [A] to drain the oil.
○
The oil in the filter can be drained by removing the filter
(see Oil Filter Change).
•
Replace the oil drain bolt gasket with a new one.
•
Tighten:
Torque - Engine Oil Drain Bolt: 20 N·m (2.0 kgf·m, 14 ft·lb)
•
Pour in the specified type and amount of oil.
Engine Oil
Type:
API SF or SG
API SH, SJ or SL with JASO MA
Viscosity:
SAE 10W-40
Amount:
2.1 L (2.2 US qt)
(When filter is not removed)
2.2 L (2.3 US qt)
(When filter is rem oved)
2.6 L (2.7 US qt)
(When engine is completely dry)
NOTE
○
Although 10W-40 engine oil is the recommended oil
for most conditions, the oil viscosity may need to be
changed to accommodate atmospheric conditions in
your riding area.
Oil Filter Replacement
•
Drain the engine oil.
•
Remove the oil filter [A] with the oil filter wrench [B].
Special Tool - Oil Filter Wrench: 57001-1249