Service manual

STEERING 14-11
Steering
Tie-rod End Removal
•
Removethetie-rod(seeTie-rodRemoval).
•
Holding the tie-rod flattened area [A], loosen the locknut
[B] and unscrew the tie-rod end [C].
NOTE
○
The locknut near the L mark on the tie-rod has left-hand
threads. Turn the wrench clockwise for loosening.
CAUTION
Do not remove the grease seal. It is packed with
grease.
Tie-rod End Installation
•
Check that the boot lip [A] is on the shank [B].
•
Install the tie-rod ends so that the tie-rod has the correct
length [A], and both visible thread lengths [B] are equal.
Tie-rod Length
Standard: 388.5 mm (15.30 in.)
•
Tighten:
Torque - Tie-rod Locknuts: 37 N·m (3.8 kgf·m, 27 ft·lb)