Service manual

14-10 STEERING
Steering
•
Drive the bearing [A] out using a suitable bearing driver
from the bearing driver set.
Special Tool - Bearing Driver Set: 57001-1129
Steering Knuckle Bearing Installation
•
The marked side of the bearing faces outward.
•
Press in the bearing until it is bottomed.
[A] V Block
Special Tool - Bearing Driver Set [B]: 57001-1129
•
Replace the circlip with a new one.
Special Tool - Inside Circlip Pliers: 57001-143
Tie-rod Remov al
•
Remove:
Front Wheels (see Wheel Removal in the Wheels/Tires
chapter)
Cotter Pins
•
Hold the flat s urfaces of the tie-rod end with a thin wrench,
and remove the tie-rod nuts [A] and washers (see Steer-
ing Knuckle Removal).
•
Remove:
Tie-rod [B]
CAUTION
When removing the tie-rod, be careful not to bend
it. Do not loosen the locknuts [C] at the end of the
tie-rod adjusting sleeve, or the toe-in of the front
wheels will be changed.
Tie-rod Installation
•
The right and left tie-rods are identical.
•
Tighten:
Torque - Tie-rod End Nuts: 42 N·m (4.3 kgf·m, 31 ft·lb)
•
Inspect the toe-in (see Toe-in Inspection in the
Wheels/Tires chapter).