Service manual

14-8 STEERING
Steering
Steering Knuckle Removal
•
Remove:
Front Hub (see F ront Hub Removal in the Wheel/Tiers
chapter)
Cotter Pin [A]
CAUTION
Do not loosen the locknuts [B] at the ends of the
tie-rod, or the toe-in of the front wheels will be
changed.
•
Holdtheflatsurfaces[A]ofthetie-rodendwithathin
wrench [B], and remove the tie-rod end nut [C] and wash-
ers.
•
Tap the tie-rod end shaft lightly and remove the tie-rod
end from the knuckle.
•
Remove:
Cotter Pins and Steering Knuckle Joint Nuts [A]
•
Remove the knuckle joint [A] from the lower suspension
arm using a suitable joint remover [B].
•
Remove the knuckle j oint [A] from the upper suspension
arm using a suitable joint remover [B].