Service manual

Table Of Contents
STEERING 14-7
Steering
Steering Stem Installation
Fill grease up the seal grooves [A] in the steering stem
bearing.
Install:
Collar
Tighten:
Torque - Steering Stem Bottom End Nut: 62 N·m (6.3 kgf·m,
46 ft·lb)
Bend both ends of the cotter pin.
Apply a non-permanent locking agent to the steering stem
bearing joint bolts [A].
Tighten:
Torque - Steering Stem Bearing Joint Bolts: 22 N·m (2.2
kgf·m, 16 ft·lb)
Apply grease to the inside of steering clamp [A].
Install:
Grease Seals [B]
Install:
Collars [A]
Apply above grease to the inside of steering c lamp [B].
Tighten:
Torque - Steering Stem Clamp Bolts [A]: 25 N·m (2.5 kgf·m,
18 ft·lb)
Tie-rod End Nuts: 42 N·m (4.3 kgf·m, 31 ft·lb)
Bend the tabs of the washer [B] toward the bolt head.
Inspect the toe-in (see Toe-in Inspection in the
Wheels/Tires chapter).