Service manual

SUSPENSION 13-15
Suspension Arms
•
Remove:
Screw [A]
Bolts [B]
Axle Guard [C]
•
Remove:
Rear Shock Absorber Mounting Bolt [A] and Nut (lower)
Suspension Arm Bolts and Nuts [B]
Rear Lower Suspension Arm [C]
Rear Suspension Arm Installation
•
Install:
Rear Upper Suspension Arm
Rear Lower Suspension Arm
Suspension Arm Pivot Bolts and Nut (temporary)
Rear Shock Absorber Mounting Bolt (lower)
Stabilizer Joint
•
Tighten:
Torque - Rear Suspension Arm Pivot Nuts: 46 N·m (4.7
kgf·m, 34 ft·lb)
Rear Shock Absorber Mounting Nuts: 34 N·m (3.5
kgf·m, 25 ft·lb)
Stabilizer Joint Nut: 46 N·m (4.7 kgf ·m, 34 ft·lb)
Rear Knuckle Mounting Nuts: 46 N·m (4.7 kgf·m,
34 ft·lb)
○
Hold the joint bolt with an Allen wrench, and tighten the
nut.
•
Install:
Front Wheels (see Wheel Installation in the Wheels/Tires
chapter)
Rear Suspension Arm D is assembly
Rear Upper Suspension Arm
•
Remove out the bushings [A].