Service manual

11-66 F INAL DRIVE
Rear Final Gear Case
Rear Final Gear Cas e Right Cover Assembly
[A] Rear Final Gear Case Right Cover
•
Press:
Ball Bearing (until bottomed)
Special Tool - Bearing Driver, 54.3 [B]: 57001-1488
[A] Rear Final Gear Case Right Cover
[B] Ball Bearing
•
Press:
Oil Seal [C] (until bottomed)
Special Tool - Bearing Driver Set: 57001-1129
•
Apply Grease:
Oil Seal Lips [D]
Rear Final Gear Cas e Front Cover Assembly
[A] Rear Final Gear Case Front Cover
•
Press:
Ball Bearing [B] (until bottomed)
Special Tool - Bearing Driver Set: 57001-1129
•
Press the faces of the oil seals [C] are flush with the ends
of the housing.
•
Apply Grease:
Oil Seal Lips
Rear Final Gear Case Assembly
[A] Rear Final Gear Case
•
Press:
Ball Bearing [B] (until bottomed)
Oil Seal [C] (until bottomed)
Special Tool - Bearing Driver Set: 57001-1129
•
Apply Grease:
Oil Seal Lip
•
Press the face of the needle bearing [D] so that i ts surface
is flush with the end of the housing.
•
Insert the spring pin [E].