Service manual

FINAL DRIVE 11-65
Rear Final G ear Case
•
Remove:
Steel Balls [A]
•
Remove:
Pinion Gear Bearing Holder [A]
○
Hold the rear final gear case [A] in a vise, and remove the
bearing holder using the socket wrench [B].
Special Tool - Socket Wrench, Hex 50: 57001-1478
○
If it is difficult to break free the holder, apply the heat to it
to softer the locking agent.
•
Remove:
Pinion Gear Unit [A]
Shim(s) [B]
•
Drill out the spring pin [A] with a drill bit of 3 mm (0.12 in.)
diameter and remove it.
•
Remove the needle bearing [B].