Service manual

FINAL DRIVE 11-59
Rear Axle
•
Squeeze about half a tube (30 grams) of the special
grease [A] into the bearing cup [B].
•
Insert the balls and cage assembly in the bearing cup
strongly.
•
Install the new retaining ring [A] so that the opening [B] is
aligned with one of the projections [C].
•
Squeeze the remaining special grease [A] into the inboard
joint boot [B].
•
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
•
Hold the axle at this s etting.
Standard Length of Assembling:
Inboard:
162.2 mm (6.386 in.) [A]
•
Pinch the boot bands [A] with a suitable tool [B] to install
them.
○
Compress the suitable tool with a vice, if necessary.