Service manual

11-56 F INAL DRIVE
Rear Axle
•
Place the special grease tube nozzle in the bore of the
housing and squeeze the tube [A] until the grease comes
out from the joint bearing.
•
Tap the shaft end [A] straight with a plastic hammer until
it is locked by the circlip.
•
Squeeze all of the special grease [A] into the new boot
[B].
•
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
•
Hold the axle at this setting.
Standard Length of Assembling:
Outboard: 224.82 mm (8.850 in.) [A]
•
Pinch the boot bands [A] with a suitable tool [B] to install
it.
○
Compress the suitable tool with a vice, if necessary.