Service manual

Table Of Contents
FINAL DRIVE 11-51
Front Final Gear Case
Correct Tooth Contact Pattern: No adjustment is required.
A. Ring Gear
B. Pinion Gear
C. Heel
D. Bottom
E. Top
F. To e
Incorrect Tooth Contact Patterns (Example 1)
Decrease the thickness of the pinion gear shim(s) by 0.1 mm (0.004 in.) to correct the pattern
shown above. Repeat in 0.1 mm (0.004 in.) steps if necessary.
A. Ring Gear
B. Pinion Gear
C. Heel
D. Bottom
E. Top
F. To e
Incorrect Tooth Contact Patterns (Example 2)
Increase the thickness of the pinion gear shim(s) by 0.1 mm (0.004 in.) to correct the pattern shown
above. Repeat in 0.1 mm (0.004 in.) steps if necessary.
A. Ring Gear
B. Pinion Gear
C. Heel
D. Bottom
E. Top
F. To e