Service manual

FINAL DRIVE 11-35
Front Final Gear Case
Variable Differential Control Cable Inspection
•
With the variable differential control cable disconnected at
both ends, the cable should move freely within the cable
housing.
If the cable does not move freely [A] after lubricating, if the
cable is frayed [B], or if the housing is kinked [C], replace
the cable.
Front Final Gear Case Removal
•
Drain the gear case oil (see Front Final Gear Case Oil
Change in the Periodic M aintenance chapter).
•
Remove:
Steering Stem (see Steering Stem Removal in the Steer-
ing chapter)
Front Axles (see Front Axle Removal)
Right Upper Suspension Arm (see Front Suspension
Arm R emoval in the S uspension chapter)
Right Front Shock Absorber (see Front Shock Absorber
Removal in the Suspension chapter)
Front Propeller Shaft (see Front Propeller Shaft Re-
moval)
•
Cut the band [A].
•
Loosen the clamp screw [B].
•
Remove:
Clamps [C]
Air Duct [D]
Actuator Lead Connector [E] (disconnect)
•
Remove:
Brake Hose Joint Bolt [A]
Bracket Bolts [B]
Vent Hose [C]