Service manual

11-34 F INAL DRIVE
Front Final Gear Case
Variable Differential Control Lever I nstallation
•
Install:
Variable Differential Control Cable Upper End
Variable Differential Control Lever [A]
•
Apply a non-permanent locking agent to the variable dif-
ferential control lever bolt [B] and tighten it.
Torque - Variable Differential Control Lever Bolt: 3.4 N·m
(0.35 kgf·m, 30 in·lb)
•
Install:
Variable Differential Control Lever Bolt, Washer [C] and
Collar [D]
Cable Stopper Plate [E]
Plate Bolt [F]
•
Check the variable differential c ontrol lever play (see Vari-
able Differential Control Lever Play Inspection in the Pe-
riodic Maintenance chapter).
Variable Differential Control Cable In stallation
•
Lubrication the variable differential control cable before
installation.
•
Route the cable correctly according to the Cable, Wire,
and Hose Routing in the Appendix chapter.
WARNING
Operation with a n improperly adjusted, incorrectly
routed, or damaged cable could result in an unsafe
operating condition.
•
Tighten:
Torque - Variable Differential Control Cable Locknut [A]: 16
N·m (1.6 kgf·m, 12 ft·lb)
•
Check the variable differential c ontrol lever play (see Vari-
able Differential Control Lever Play Inspection in the Pe-
riodic Maintenance chapter).
Variable Differential Control Cable Lubrication
Whenever the variable differential control cable is re-
moved, lubricate the cable as follows:
•
Apply a small amount of multi-purpose grease to the cable
(both ends).
•
Lubricate the cable with a penetrating aerosol cable lubri-
cant through the pressure cable luber.