Service manual

FINAL DRIVE 11-33
Front Final Gear Case
Front Final Gear Case Oil Level Inspection
•
Park the vehicle so that it is level, both side-to-side and
front-to-rear.
•
Remove the filler cap.
CAUTION
Be careful not to allow any dirt or foreign materials
to enter the gear case.
•
Check the oil level. The oil level should come to the bot-
tom of the filler opening [A].
If it is insufficient, first check the front final gear case for
oil leakage, remedy it if necessary, and add oil through
the filler opening. Use the same type and brand of oil that
is already in the final gear case.
•
Be sure the O-ring [B] is in place, and tighten the filler cap
[C].
○
Apply grease to the O-ring.
Torque - Front Final Gear Case Oil Filler Cap: 29 N·m (3.0
kgf·m, 22 ft·lb)
Front Final Gear Case Oil Change
•
Refer to the Front Final Gear Case Oil Change in the Pe-
riodic Maintenance chapter.
Variable Differential Control Lever Play Inspection
•
Refer to the Variable Differential Control Lever Play In-
spection in the Periodic Maintenance chapter.
Variable Differential Control Le ver Play
Adjustment
•
Refer to the Variable Differential Control Lever Play Ad-
justment in the Periodic Maintenance chapter.
Variable Differential Control Lever Removal
•
Remove:
Handlebar Cover
Plate Bolt [A]
Cable Stopper Plate [B]
Variable Differential Control Lever Bolt [C], Washer and
Collar
Variable Differential Control Lever [D]
Variable Differential Control Cable Upper End