Service manual

11-32 F INAL DRIVE
Front A xle
•
Tighten the small band.
•
Squeeze the remaining special grease [A] into the inboard
joint boot [B].
•
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
•
Hold the axle at this setting.
Standard Length of Assembling
Right Front Axle:
127 mm (5.00 in.) [A]
Left Front Axle: 127 mm (5.00 in.) [A]
•
Open the edge of the boot in order to eqalize the air pres-
sures.
•
Tighten the large band [A] and bend the tangs securely to
hold down the end of the band.
Maximum Outside Diameter of Band: 77.2 m m (3.04 in.)
(After tightening the outside diameter)
•
While the band is held at the diameter above, tap down
the tangs [A] of the clamp.