Service manual

FINAL DRIVE 11-17
Output B evel Gears
Output Drive Bevel Gear Assembly
•
Press the new inner ball bearing until it is bottomed.
Special Tool - Bearing Driver Set [A]: 57001-1129
•
Apply a non-permanent locking agent to the threads of
the bearing holder [A] and tighten it so that the deep side
[B] faces outward.
Torque - Bearing Holder: 120 N·m (12 kgf·m, 88 ft·lb)
•
Press the output drive bevel gear until it is bottomed.
•
Apply a non-permanent locking agent to the threads of
the bevel gear holder nut [A] and tighten it so that the
projection side [B] faces outward.
Special Tool - Socket Wrench: 57001-1482 [C]
Torque - Bevel Gear Holder Nut: 157 N·m (16 kgf·m, 116
ft·lb)
•
Press the new outer ball bearing until it is bottomed.
Output Driven Bevel Gear Removal
•
Remove:
Engine (see Engine Removal in the Engine Removal/In-
stallation chapter)
Output Driven Bevel Gear Housing Bolts [A]
Output Driven Bevel Gear Housing [B]