Service manual

WHEELS/TIRES 10-13
Front Hub
Front Hub Removal
•
Remove:
Cap [A]
Cotter Pin [B] (cut)
•
Loosen the axle nut [C].
•
Remove the front wheel (see Wheel Removal).
•
Remove the caliper by taking off the mounting bolts [A],
and let the caliper [B] hang free.
•
Remove the axle nut [A], and pull off the front hub [B]
together with the brake disc.
•
Separate the brake disc from the front hub (see Front
Brake Disc Removal in the Brakes c hapter).
Front Hub Installation
•
Install the front brake disc (see Front Brake Disc Installa-
tion in the Brakes c hapter).
•
Wipe dry the spline portion of the hub.
•
Wipe dry the threads and seating surface of the nuts.
•
Tighten:
Torque - Front Axle Nuts: 197 N·m (20 kgf·m, 145 ft·lb)
•
Insert a new cotter pin [A].
NOTE
○
When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle shaft, tighten
the nut clockwise [B] up to next alignment.
○
It should be within 30 degree.
○
Loosen once and tighten again when the slot goes past
the nearest hole.