Service manual

9-22 CRANKSHAFT/TRANSMISSION
Transmission
•
Remove:
Circlip [A]
Special Tool - Outside Circlip Pliers: 57001-144
•
Remove:
Spacer [A]
Idle Gear Assembly [B]
Washers and Spacer [C]
Low and High Gears [D]
•
Remove:
Needle Bearings [A]
•
Remove the driven shaft [B] from the crankcase using a
press.
Transmission Installation
•
Insert the driven shaft in the crankcase until it is bottomed
using a press.
•
Apply engine oil to the needle bearings and install them.
•
Install the following parts on the low gear [A].
Needle Bearings [B]
Spacer [C] (P/No. 92026-1599, 48.2 × 54.3 × 1.0)
High Gear [D]