Service manual

CRANKSHAFT/TRANSMISSION 9-21
Transmission
○
Do not lean the tie-rod rear end after tightening the front
locknut.
Right [L]
Wrong [M]
•
Check that the shift lever moves from right to left automat-
ically.
•
Install:
Spring [N]
Trim Seal [O]
•
Align the mark [P] of the grip [Q] with the projection [R] on
the guide.
•
Tighten:
Torque - G rip Holder Nut [S]: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Transmission Removal
•
Remove:
Shift Shaft Cover Bolts [A]
Shift Shaft Cover [B]
•
While opening the shift shaft spring end, remove the shift
shaft [A].
Special Tool - Outside Circlip Pliers: 57001-144
•
Remove:
Shift Shaft Spring Bolt [B]
•
Split the crankcase (see Crankcase Disassembly).
•
Remove:
ReverseIdleShaft[A]
Spacer [B]
Reverse Drive Gear [C], Needle Bearing, and Spacer
Shifter [D]
Shift Rod [E]