Service manual

9-20 CRANKSHAFT/TRANSMISSION
Transmission
•
Install:
Guide [A]
•
Tighten:
Torque - Shift Lever Guide Mounting Bolts [B]: 19.6 N·m
(2.0 kgf·m, 14 ft·lb)
•
Set the lever assembly in the neutral position [C] while
turning the tie-rod [D].
NOTE
○
Do not turn the shift shaft [E] when setting the lever
assembly on neutral position.
○
Turn the tie-rod counterclockwise until the rod [F] of the
shift lever assembly contacts with the neutral position [G]
of the guide [H]. At that time, the clearance [I] between
the rod and guide is 0 mm.
○
Move the rod [F] to right side and check it returns to left
side automatically.
•
Tighten:
Torque - Tie-rod End Rear Locknut [J]: 9.8 N·m (1.0 kgf·m,
87 in·lb)
•
Holding the rear tie-rod end, and tighten the front locknut
[K].
Torque - Tie-rod End Front Locknut: 9.8 N·m (1.0 kgf·m, 87
in·lb)
NOTE
○
The front locknut has left-hand threads.