Service manual

Table Of Contents
CRANKSHAFT/TRANSMISSION 9-19
Transmission
Shift Lever Installation
Twist the tie-rod end [A] and tie-rod end locknut [B] to
bottom of the screw and then turn back to dimension with
77° ±10° [C] as shown.
Tighten the l ocknut against the tie-rod end:
Torque - Tie-rod End Locknut: 19.6 N·m (2.0 kgf·m, 14 ft·lb)
Apply molybdenum disulfide grease:
Outside of Tie-rod End Collar [D]
Apply grease to the oil seals, and install them.
Tighten:
Torque - Tie-rod End Bolt [E]: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Align the mark [A] on the shaft end with the slit [B] of the
shift shaft lever.
Position the shift shaft lever end [C] on the boss-center
[D] of the crankcase.
Install:
Bracket [E]
Shift Lever Assembly Nut [F]
Tighten:
Torque - Shift Lever Assembly Nut: 20 N·m (2.0 kgf·m, 14
ft·lb)
Tie-rodEndNut[G]:19.6N·m(2.0kgf·m,14ft·lb)