Service manual

6-24 CONVERTER SYSTEM
Driven Pulley
If the sheave bushings [A] are damaged or worn, replace
the movable sheave.
Sheave Bushing Inside Diameter
Standard: 40.000 ∼ 40.0 3 9 mm (1.574 8 ∼ 1.5763 in.)
Service Limit: 40.07 mm (1.578 in.)
•
Inspect seals for damage.
If seals are damaged, replace the movable sheave.
If the splines [A] are damaged or worn, replace the fixed
sheave.
If the spring is damaged or worn, replace the spring.
Spring Free Length [A]
Standard: 75.1 mm (2.96 in.)
If the spring c oils are distorted, replace the spring.
Driven Pulley Assembly
•
Clean off any grease or dirt on the movable and fixed
sheaves, and dry them with a clean cloth.
•
Install:
Spacers [A] (see Converter Drive Belt Deflection Adjust-
ment in the Periodic Maintenance chapter)
•
Apply grease to the oil seal lips [A].
•
Press the oil seals [B] in the movable sheave assembly
so that the oil seal surface is flush [C] with the sleeve end.
•
Apply [D] grease (WR500-No.2 (KYODO YUSHI),
POWER LITE WR #2 (KYODO YUSHI), or SERAN-HV
(TOTAL FINA)) to the inner surfaces of the busings.