Service manual

6-20 CONVERTER SYSTEM
Drive P ulley
•
Install the drive pulley, stepped waster and two washers
on the drive pulley bolt as shown.
Crankcase Side [A]
Stepped Washer [B]
Two Washers [C]
Bolt Head Side [D]
•
Remove the three cover bolts [A] and install the drive pul-
ley holder [B].
Special Tool - Drive Pulley Holder: 57001-1620
•
Tighten:
Torque - Drive Pulley Cover Bolts: 13 N·m (1.3 kgf·m, 115
in·lb)
Drive Pulley Bolt [C] (new, left-hand threads): 93
N·m (9.5 kgf·m, 68 ft·lb)
•
Remove the drive pulley holder and install three drive pul-
ley cover bolts to the specified torque.
•
Adjust the installation length [A] of the drive pulley be-
tween the surface of the crankcase [B] and the collar [C]
on the drive pulley as followings.
Drive Pulley Installation Length [A]
Standard: 149.85 ∼ 150.95 mm (5.900 ∼ 5.943 in.)