Service manual

6-18 CONVERTER SYSTEM
Drive P ulley
•
Turn the m ovable sheave counterclockwise.
•
Measure the resulting clearance [A] between the shoe [B]
and the post [C] on the movable sheave at two positions
as shown.
[D] Arrow Mark
Shoe Side Clearance
Standard: up to 0.20 mm (0.008 in.), and there m ust
be kept a clearance which the movable
sheave [E] moves smoothly until it
touchesthefixedsheave[F]withitsown
weight.
If the clearance is not the specified range, adjust it using
the following shoes.
Part Number Thickness
Standard Shoe
49048-1090
7.5 mm (0.295 in.)
49048-1087
7.2 mm (0.283 in.)
49048-1088
7.3 mm (0.287 in.)
49048-1089
7.4 mm (0.291 in.)
49048-1091
7.6 mm (0.299 in.)
49048-1092
7.7 mm (0.303 in.)
49048-1093
7.8 mm (0.307 in.)
49048-1094
7.9 mm (0.311 in.)
Adjustment Shoes
49048-1095
8.0 mm (0.315 in.)
If the clearance is not the specified range after the above
shoes are replaced, use the spacer [A] (92026-0038) of
the option part.
[B] Shoe
[C] Spider
[D] Post
[E] Clearance
Drive Pulley Assemb ly
•
Install the ramp weight [A] as shown.
•
Tighten:
Torque - Ramp Weight Nuts [B]: 6.9 N·m (0.70 kgf·m, 61
in·lb)
•
Check that the ramp weights swing smoothly.