Service manual

FUEL SYSTEM (DFI) 3-97
Fuel Tank
•
Install:
Hose [A]
Clamps [B]
•
Insert the fuel hose joint [A] straight onto the delivery pipe
until the hose joint clicks.
•
Push [B] the joint lock [C] .
•
Push and pull [A] the hose joint [B] back and forth more
than two times and make sure it is locked and doesn’t
come off.
WARNING
Make sure the hose joint is installed correctly on the
delivery pipe by sliding the joint, or the fuel could
leak.
If it comes off, r einstall the hose joint.
•
Connect the fuel pump connector and the battery (–) cable
terminal.
Fuel Tank Cleaning
WARNING
Clean the tank in a well-ventilated area, and take
care that there are no sparks or flame anywhere
near the working area. Because of the danger or
highly flammable liquids, do not use gasoline or
low-flash point solvents to clean the tank.
•
Remove:
Fuel Tank (see Fuel Tank Removal)
Fuel Pump (see Fuel Pump Removal)
•
Remove the fuel pump inlet hose and the fuel pump (see
Fuel Pump Removal).
•
Pour some high-flash point solvent into the fuel tank and
shake the tank to remove dirt and fuel deposits.
•
Draw the solvent out of the fuel tank.
•
Dry the tank with compressed air.
•
Install the fuel pump (see Fuel Pump Installation).
•
Install the fuel tank (see Fuel Tank Installation).