Service manual

FUEL SYSTEM (DFI) 3-91
ISC Valve
ISC Valve Removal
•
Remove:
Front Fender (see Front Fender Removal in the Frame
chapter)
ISC Valve Tube (Front) [A]
ISC Valve Tube (Rear) [B]
ISC Valve Tube (Primary) [C]
Connector [D]
Bolts [E]
ISC Valve [F]
ISC Valve In stallation
•
Install the ISC valve.
•
Tighten:
Torque - ISC Valve Mounting Bolts: 8.8 N·m (0.90 kgf·m, 78
in·lb)
ISC Valve Inspection
•
Remove:
Front Fender (see Front Fender Removal in the Frame
chapter)
ISC Valve Connector [A]
•
Connect the hand tester to the following pair of terminals.
Special Tool - Hand Tester: 57001-1394
•
Set the hand tester to the 10 Ω range.
Connections:
Terminal A-B,
Terminal B-C
Terminal D-E, Terminal E-F
Standard Resistence:
28.8 ∼ 31.2 Ω at 20°C(68°F)
If the tester does not read as specified, replace the ISC
valve.