Service manual

3-80 FUEL SYSTEM (DFI)
Fuel Pump
•
Remove:
Fuel Pump Bolts [A]
Plate [B]
Fuel Pump [C]
O-ring
Fuel Pump Installation
•
Remove dirt or dust from the fuel pump [A] by lightly ap-
plying compressed air.
•
Install:
Fuel Pump [A]
O-ring
•
Install the plate [B] so that fit the projections [C] and hel-
lows [D] of the fuel pump and plate.
•
Tighten the fuel pump bolts to a snug fit, tighten them
alternating diagonally.
Torque - Fuel Pump Bolts: 4.0 N·m (0.41 kgf·m, 35 in·lb)
•
Tighten the pump bolts again alternating diagonally to
check the tightness.
•
Install the fuel hose.
•
Insert the fuel hose joint [A] straight onto the fuel pump
until the hose joint clicks.
•
Push [B] the joint lock [C].
•
Push and pull [A] the fuel hose joint [B] back and forth
more than two times and make sure it is locked and
doesn’t come off.
WARNING
Make sure the fuel hose joint is installed correctly
on the fuel pump or the fuel could leak.
If it comes off, reinstall the hose joint.
•
Connect:
Fuel Pump Connector [C]
•
Run the fuel hose correctly (see Cable, Wire and Hose
Routing section in the Appendix chapter).
•
Install the removed parts (see appropriate chapters).
•
Start the engine and check the fuel hose for leaks.