Service manual

FUEL SYSTEM (DFI) 3-53
Water Temperature Sensor (Service Code 14)
Water Temperature Sensor Removal/Installation
CAUTION
Never drop the sensor, especially o n a hard surface.
Such a shock to the sensor can damage it.
•
Drain the coolant (see Coolant Change in the Periodic
Maintenance chapter).
•
Remove:
Bolts [A]
•
Disconnect the water pipe [B] from the thermostat housing
[C].
•
Disconnect the sensor connector [A].
•
Remove the water temperature s ensor [A].
•
Apply grease to new O-ring on the water temperature sen-
sor.
•
Install the water temperature sensor.
•
Fill the engine with coolant and bleed the air from the cool-
ing system (see Coolant Change in the Periodic Mainte-
nance chapter).