Operating instructions

DR
®
ALL-TERRAIN
™
MOWER Assembly, Installation & Maintenance Instructions for the 42" Lawn Mower Deck 7
To Install the Lawn Mower Deck
Your lawn deck is shipped with the belt in place on the two blade drive pulleys. However, occasionally
the belt comes off during shipping. If this occurs remove the two smaller belt covers with a ½" in
wrench or socket and place the belt back on the pulleys as shown in Figure 9 on Page 8.
1. Remove the black rectangular belt cover. Remove the two smaller black covers if necessary.
2. Line up the lawn mower deck with the
power unit and mount the deck.
3. Attach the collar and insert the pin
(Figure 8).
4. Mount the belt on engine pulley. If
necessary, place the belt around the
other pulleys as shown on the belt label
except for the pulley attached to the belt
release lever.
5. Push the belt release lever and set the
out side of the belt against the flat idler
pulley on the release lever. Hint: some
people push the lever with their foot.
6. Replace the belt covers.
Figure 8