System information

5 (Optional) If the status of the virtual machines is Not Configured or Mapping Missing, check the

inventory mappings and click Configure All again.

6 (Optional) If the status of the virtual machines is Placeholder VM creation error, check the placeholder

datastore mapping and try to recreate the placeholder virtual machines.

To recreate the placeholder for an individual virtual machine, right-click a virtual machine and

select Recreate Placeholder.

To recreate the placeholder for several virtual machines, right-click the protection group and select

Restore Placeholder VMs.

Configure Inventory Mappings for an Individual Virtual Machine in a

Protection Group

You can configure the mappings for the virtual machines in a protection group individually. This ability

allows you to use different resources on the recovery site for different virtual machines.

You can configure individual inventory mappings even if you configured site-wide inventory mappings. If

you did configure site-wide inventory mappings, you can remove protection from an individual virtual

machine and configure the folder and resource mappings to override the site-wide mappings. You can

change the network mapping for an individual virtual machine without removing protection.

You cannot specify placeholder datastores for individual virtual machines. You must map datastores on the

protected site to placeholder datastores on the recovery site at the site level. To configure a placeholder

datastore, see Configure a Placeholder Datastore in Site Recovery Manager Installation and Configuration.

Prerequisites

You created a protection group.

Procedure

1 In the vSphere Web Client, click Site Recovery > Protection Groups.

2 Select the protection group that includes the virtual machine to configure.

3 On the Related Objects tab, click the Virtual Machines tab.

4 Right-click the virtual machine and select Configure Protection.

5 Configure inventory mappings by expanding the resources whose status is Not Configured and

selecting resources on the recovery site.

You can only change the folder, resource pool, and network mappings.

6 (Optional) To apply these mappings to all protected virtual machines on the site, select the Save as

Inventory Mapping check box for each resource.

If you do not select the check box, the mapping is only applied to this virtual machine.

7 Click OK.

If Site Recovery Manager successfully applied inventory mappings to the virtual machine, the

status of the virtual machine is OK.

If Site Recovery Manager was unable to apply some or all of the inventory mappings, the status of

the virtual machine is Not Configured or Mapping Missing.

If Site Recovery Manager applied the inventory mappings but was unable to create a placeholder

virtual machine, the status of the virtual machine is Placeholder VM creation error.

8 (Optional) If the status of the virtual machine is Not Configured or Mapping Missing, select Configure

Protection again and check the inventory mappings.

Site Recovery Manager Administration

36 VMware, Inc.