User guide

www.DrRobot.com

- 13 -

Recharging

Jaguar robot uses high performance LiPo batteries. Extreme caution is needed when dealing with this type of

battery, explosion and damage could occur. Please read the Charge Station manual first and follow all the safety

rules before proceeding further.

1) Power on the Charge Station. Make sure "LiPo Charge" is displayed on the LCD screen. If not, use "Type/Stop"

button to change it to "LiPo Battery".

2) Use "INC" button to choose how to charge battery. You can choose "LiPo Charge", "LiPo Balance" or "LiPo

Fast Chg". We recommend using "LiPo Balance" charge to extend battery life and reduce risk.

3) You can use "Enter/Start" + "INC" + "DEC" buttons to change the charge current, DO NOT exceed the 5A

charging current and do not modify the battery voltage. It should be "22.2V (6S)" for Jaguar robot.

4) Connect the charging cable to Jaguar charging socket; make sure it is fastened well.

5) Turn the Power switch (CCW) to charge position.

6) Keep pressing "Enter/Start" button for few seconds, the charge station will check the battery and display what

the reading is. It should be same as your settings above.

7) If everything is right, you can press "Enter/Start" button again to start charging.