Quick User Guide

www.DrRobot.com

- 20 -

Remote Monitoring and Tele-operation

Step 1: If Internet remote monitoring/control is required, you need to connect the wireless router WAN port to

your broadband Internet modem. You need to find out the public IP assigned by your ISP. (You should be able to

find this information from the router status page) This IP will be used by the remote client to connect to the host

PC and the devices on the robot.

If firewall is in-place in your network, you also need to make sure all the network ports used by 7050, 7080 and

7090 on the server and remote client sides are not blocked for the Internet remote monitoring/control tasks to

operate properly.

Step 2: Installing the Sputnik Remote Control program from the installation CD.

“DrRobotSputnikRemoteControl.exe” program allows you to remotely control the robot, obtain main robot

sensor information, view, listen and talk through robot.

Step 3: Run the DrRobotSputnikRemoteControl.exe.

Step 4: Enter or confirm the remote server and other devices’ IP. When you are connecting from public network,

your server IP must be a public IP, and with the pre-configured router settings, all the devices on the robot will

share the same public IP with the server IP. Then click the “Start Service”.

Server PC IP

Connect to Server PC