Quick Start Guide

- 20 -

Network Connection and Login Information

Network Settings

The included pre-configured wireless 802.11 b/g router has the following pre-set settings:

SSID dri Router LAN 192.168.0.200

WEP 128bits Login ID admin

KEY 112233445566778899AABBCCDD Password drrobot

Key Type Open Key

WiFi module 1 connects to two serial devices through channel I and II (TCP/IP port 10001 and 10002

respectively). They are pre-configured as below:

Name Robot WiFi Module 1 IP 192.168.0.202

Channel-I

(10001)

115200, 8,N,1, no flow control, UDP,

Datagram 01, remote IP:0.0.0.0

Channel-II

(10002)

115200, 8,N,1, no flow control, UDP,

Datagram 01, remote IP:0.0.0.0

WiFi module 2 connects to serial devices through channel II (TCP/IP port 10002). It is pre-configured as below:

Name Robot WiFi Module 2 IP 192.168.0.203

Channel-I

(10001)

115200, 8,N,1, no flow control, TCP,

Datagram 01, remote IP:0.0.0.0

Channel-II

(10002)

115200, 8,N,1, no flow control, TCP,

Datagram 01, remote IP:0.0.0.0

Advanced Network Settings

It’s possible to use different network settings (e.g. IP) for the server PC, but the “Virtual Server” settings on the

router must also be changed accordingly in order for the Internet remote monitoring feature to work properly.

You could also change the router settings such as IP and SSID etc. If you need to do so, you are required to

change the network settings on the WiFi modules on the robot by following the guidelines as illustrated on the

WiFi Module manual.