Manual

www.DrRobot.com

V.24.09.13

- 14 -

Recharging

Jaguar robot uses high performance LiPo batteries. Extreme caution is needed when dealing with this type of

battery, explosion and damage could occur. Please read the Charge Station manual first and follow all the safety

rules before proceeding further.

1) Turn off the robot

2) Loose the screws of Battery Box, disconnect the 2-Pin Tamiya connector

and take the Battery Box out.

3) Power on the Charge Station. Use

to make sure "LiPo BALANCE" is

displayed on the LCD screen. If not, use "Type/Stop" button to change

battery type to "LiPo Battery" and press

to set charging mode to “LiPo

BALANCE” .

4) You can use

+ / + buttons to change the charge

current, DO NOT exceed the 2A charging current and do not modify the battery voltage. It should be "22.2V

(6S)" for Jaguar robot.

5) Connect the charging 7-Pin & 4-pin connectors to charger

6) Press

button for few seconds, the charge station will check the battery and display what the reading is. It

should be same as your settings above.

7) If everything is right, you can press

button again to start charging.

8) Press

to switch the display to show the battery status. The display

should show each battery reading as below image.

* Note: If any battery reading is missing, please turn off the charging station and turn the Power switch to “OFF”,

and check the 7-pin connector, make sure it is connect well.

9) Keep the charger away from children and pet at all time! Never leave the charger unsupervised when it

is connected to its power supply. For more detail about charger station operation, warning and error message,

maintenance and safety message, please refer to “Intelligent Digital Balance Charger Operating Manual”.