Manual

Copyright © 2013, Dr Robot Inc. All Rights Reserved. www.DrRobot.com V18.09.13
- 15 -
6) Press button for few seconds, the charge station will check the battery and display what the reading is. It
should be same as your settings above.
7) If everything is right, you can press
button again to start charging.
8) Press
to switch the display to show the battery status. The display
should show each battery reading as below image.
* Note: If any battery reading is missing, please turn off the charging station and turn the Power switch to “OFF”,
and check the 7-pin connector, make sure it is connect well.
9) Keep the charger away from children and pet at all time! Never leave the charger unsupervised when it
is connected to its power supply. For more detail about charger station operation, warning and error message,
maintenance and safety message, please refer to “Intelligent Digital Balance Charger Operating Manual”.
IV. Hardware and Electronics
Network Settings
Wireless Router Setting
The included pre-configured wireless 802.11 B/G router has the following pre-set settings:
SSID DriJaguar Router LAN 192.168.0.245
WEP 128bits Login ID admin
KEY drrobotdrrobot Password drrobot
Key Type Open Key
Device Default Network Settings
Note: The Ethernet modules are configured to serial-to-Ethernet mode in Jaguar platform.
Ethernet Module 1 192.168.0.60
Port 1 Port Number 10001, UDP 115200. 8, N, 1, no flow control
Port 2 Port Number 10002, TCP 19200. 8, N, 1, no flow control
Ethernet Module 2 192.168.0.61
Port 1 Port Number 10001, TCP 57600. 8, N, 1, no flow control
Port 2 Port Number 10002, TCP 115200. 8, N, 1, no flow control