User Manual

www.DrRobot.com

V.04.08.18.Q

- 17 -

2) Loose the locking screws of the Battery Box, disconnect the 2-Pin battery connector and take the Battery

Box out.

3) Power on the Charge Station. Use to make sure "LiPo BALANCE" is displayed on the LCD screen. If not,

use "Type/Stop" button to change battery type to "LiPo Battery" and press to set charging mode to “LiPo

BALANCE” .

4) You can use + / + buttons to change the charge

current, DO NOT exceed the 2A charging current and do not modify the

battery voltage. It should be "22.2V (6S)" for Jaguar robot.

5) Connect the charging 7-Pin & 4-pin connectors to charger

6) Press button for few seconds, the charge station will check the battery and display what the reading is. It

should be same as your settings above.

7) If everything is right, you can press button again to start charging.

8) Press to switch the display to show the battery status. The display

should show each battery reading as shown.

* Note: If any battery reading is missing, please turn off the charging station and turn the power switch to “OFF”,

and check the 7-pin connector, make sure it connects well.

9) Keep the charger away from children and pet at all time! Never leave the charger unsupervised when it is

connected to its power supply. For more detail about charger station operation, warning and error message,

maintenance and safety message, please refer to “Intelligent Digital Balance Charger Operation Manual”.