User Manual

OPERATION
CLEANING AND MAINTENANCE
SPECIFICATIONS
WARRANTY
CORD STORAGE
CUSTOMER SUPPORT
Dr.Prepare products are covered by a 12-month limited warranty from the original purchase
date. If any problems occur, please contact our support team.
If the fan will not be used for long periods, we advise you to store the fan with this manual in
its original packaging in a cool, dry place.
We only provide after-sales services for products that are sold by Dr.Prepare or retailers and
distributors authorized by Dr.Prepare. If you have purchased your unit from other channels,
please contact your seller for more information about return and warranty.
If you have any questions or concerns, please send us an email at [e-mail]
Attention: Ensure the fan is turned off and unplugged before cleaning.
Take out the fan and spare parts from the packaging. Loosen 4 screws from the
bottom of your fan.
Step 2:
Step 1:
Connect one base part to the other by the slots. Align the base with the fan via screw
holes (or via the 2 holes for the pillars) and tighten the screws.
You can use the control panel or the remote control to set the fan.
Remote Control
WARNNING: Turn off the fan and unplug the adapter from the wall outlet when the fan
is not in use for long periods.
Please remove the battery pull tab before using the remote control.
Replace the battery with the same type (CR2025 Type Lithium Battery), making sure the
battery is installed correctly.
Use a soft cloth to gently wipe the outer surfaces of the fan clean.
Clean the motor's air inlet to keep it from dust and lint.
Do not immerse any part of the fan in water or other liquids.
Power supply: AC 120V~60Hz
Power: 45W
You can coil the power cord around the base and push the plug into the slot at the back of your
fan. Please refer to the picture.
Plug the fan into a wall outlet, the LED screen will display the current room temperature.
D. Base 1
E. Base 2
F. Screws (4 pcs)
1.
Press the ON/OFF button ,the fan will start at Medium speed. When the fan is running,
press the ON/OFF button once to turn off the fan.
2.
Press the SPEED button to choose the Fan Speed, including Low, Medium, and High.
The speed level is displayed on the LED screen.
3.
Press the OSC button , and the fan starts oscillating. Press this button again to stop
oscillation. The maximum oscillation angle is 70°.
5.
Press the TIMER button to set the set the timer with 1-hour increment (1-12 Hours).
6.
CONTROL PANEL
LED DISPLAY
4.
Press the MODE button select the Wind Mode among Normal Mode , Natural Mode
,and Sleep Mode .