User Manual

EDGE 540. Instruction Manual.
12
 4) Slide the two horizontal fin halves
together and carefully align them at the
possition on the fuselage. Wipe away any
excess epoxy using paper towels.
 5) Bolt the horizontal fin to the fuselage
using the 4 machine screws (3x10mm).
Double cheek that all the screws are tight
before proceeding.
VERTICAL STABILIZER INSTALLATION.
 2)Sand the aluminium tube using
sandpaper. This will improve the bond of the
epoxy to the cardboard horizontal fin.
Coat both sides of one half of the aluminium
tube with 30 minute epoxy. Next, pour some
epoxy into the cardboard horizontal fin. Use
enough epoxy to fill any gaps.
 3) Insert aluminium tube into the cardboard
of fuselage.
Remove
covering.
 1) Using a modeling knife, remove the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage. This
slot accepts the lower rudder hinge.
 2) Slide the vertical stabilizer into the slot
in the top of the fuselage. The rear edge of
the stabilizer should be flush with the rear edge
INSTALLING HORIZONTAL FIN.
 1) Remove the covering at the rear tail root
of horizontal fin as picture shown below.
Hinge.
3x10mm.